Cleaning And Care; Storage - Silvercrest STYG 2000 A2 Bedienungsanleitung

NOTE
The indicator lamp 6 illuminates while the
►
appliance is heating up to the set temperature
level. When the temperature level has been
reached, the indicator lamp 6 goes out.
However, this can always illuminate and go
out again. This indicates that the set tempera-
ture has briefl y fallen and the appliance is
heating itself back up.
2) Apply a little vegetable oil to the griddle 4.
NOTE
► Excess fat or other fl uids will run into the fat
drip tray 3!
3) Place the food to be grilled on the griddle 4.
Turn the food over after a while, as required.
4) Remove the food from the griddle 4 with
the help of heat-resistant plastic or wooden
implements (e.g. a wooden spatula 8) once
it is ready.
5) Turn the thermostat 5 to "0".
6) Remove the plug from the mains power socket.

Cleaning and care

DANGER – ELECTRIC SHOCK!
► Before cleaning the appliance, disconnect
the plug from the mains power socket! Risk of
electric shock!
Always remove the thermostat 5 from the
►
socket 1 before cleaning the appliance.
NEVER immerse the appliance in water or
other liquids!
WARNING!
THERE IS A RISK OF INJURY!
► Always allow the appliance to cool down
before cleaning it. Otherwise there is a risk
of burns!
STYG 2000 A2
ATTENTION! DAMAGE TO PROPERTY!
► Do not use abrasive or aggressive cleaning
materials. These could damage the surfaces!
Use a wooden spatula 8 to push any excess
■
fat or liquid through the outlet 2 into the fat
drip tray 3. Wipe up any remaining fat using
a kitchen towel.
Wipe the griddle 4 with a moist cloth.
■
NOTE
► If any stubborn residue should still adhere to
the griddle 4, use a little detergent. After
this, wipe the griddle 4 with clean water.
Ensure that no detergent residues remain on
the griddle 4.
► If you have used detergent to clean the
griddle 4, make sure that you rub it lightly
with oil afterwards!
Clean the thermostat 5 with a moist cloth.
■
For stubborn residues use a mild detergent on
the cloth.
Ensure that the thermostat 5 is completely
dry before operating it again.
Clean the wooden spatula 8 and the fat
■
drip tray 3 in warm water. Add a little mild
detergent.
Rinse all the parts off using clean water. Ensure
that all parts are dry before reusing.
NOTE
The fat drip tray 3 can be cleaned in a
►
dishwasher.

Storage

■ Store the cleaned appliance in a clean, dust-free
and dry location.
GB
17