Troubleshooting - Electrolux GK78TSITO Benutzerinformation

Other remotely controlled
appliances may block the
signal. Do not use any such
appliances near to the hob
while Hob²Hood is on.
Cooker hoods with the Hob²Hood
function
To find the full range of cooker hoods
which work with this function refer to our

9. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
9.1 What to do if...
Problem
You cannot activate or
operate the hob.
You cannot select the
maximum heat setting
for one of the cooking
zones.
An acoustic signal
sounds and the hob de‐
activates.
An acoustic signal
sounds when the hob is
deactivated.
consumer website. The Electrolux cooker
hoods that work with this function must
have the symbol
Possible cause
The hob is not connected
to an electrical supply or it
is connected incorrectly.
The fuse is blown.
You do not set the heat
setting for 10 seconds.
You touched 2 or more
sensor fields at the same
time.
Pause operates.
There is water or fat stains
on the control panel.
The other zones consume
the maximum available
power.
Your hob works properly.
You put something on one
or more sensor fields.
ENGLISH
.
Remedy
Check if the hob is correctly
connected to the electrical
supply.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali‐
fied electrician.
Activate the hob again and
set the heat setting in less
than 10 seconds.
Touch only one sensor field.
Refer to "Additional func‐
tions".
Clean the control panel.
Reduce the heat setting of
the other cooking zones con‐
nected to the same phase.
Refer to "Power manage‐
ment".
Remove the object from the
sensor fields.
21