Setting The Radio-Controlled Alarm Clock Into Operation - Auriol Z31408A Bedienungsanleitung

Operation
Do not use the clock in reinforced concrete buildings,
- e. g. airports, high-rises, factories or basements. This
can seriously disrupt reception of the radio signal.
Do not start radio reception in a moving vehicle, e. g.
car or train. Reception of the radio signal by the device
can disrupt the vehicle electronics.
Do not expose the clock to temperatures below --20 °C
for any length of time.
Setting the radio-controlled alarm
clock into operation
Remove the protective foil before first use.
Open the battery compartment on the back of the
20
clock.
Insert two AAA batteries.
Note: Make sure that the polarity is correct when
you insert the batteries. This is indicated in the battery
compartment.
e Close the battery compartment.
GB/IE 15
86663_aur_Funkwecker_Content_LB3.indd 15 21.01.13 13:25