If you accidentally press the SET button (3) again, the hours start
blinking again. Press the SET button (3) as many times as necessary
until no digits are blinking.
Setting the Alarm Time
This function allows you to set your everyday alarm.
-
Turn the housing so that the alarm clock is displayed (see figure [7]).
-
Press the SET button (3) once. The hour indicator will start blinking.
Press the ADJ button (2) multiple times to set the alarm hour.
-
You can also keep the ADJ button (2) pressed down to accelerate the
digit adjustment.
Press the SET button (3) again. The minute indicator will start blinking.
-
Press the ADJ button (2) multiple times to set the alarm minutes.
-
Press the SET button (3) again. You have finished setting the alarm
-
and the alarm becomes enabled automatically.
A bell icon indicates that the alarm has been enabled.
To disable the alarm, press the SET button (3) once.
At the set alarm time, the device will emit an acoustic alarm signal.
Additionally, the housing will start blinking, alternating its dual colours.
Press any button or turn the device to disable the alarm. The set alarm
time will remain active, however, and the alarm will trigger again after 24
hours.
To set a new alarm time or to re-enable a previously disabled alarm,
simply repeat the steps for setting the alarm time.
10 - English