Electrolux EOO3410 Benutzerhandbuch Seite 19

• To clean metal surfaces use a usual
cleaning agent.
• Clean the oven interior after each use.
Then you can remove dirt more easily
and it does not burn on.
• Clean stubborn dirt with a special oven
cleaner.
• Clean all oven accessories after each
use and let them dry. Use a soft cloth
with warm water and a cleaning agent.
• If you have nonstick accessories, do
not clean them using aggressive
agents, sharp-edged objects or a dish-
washer. It can destroy nonstick coating.
Removing the shelf supports
1
Installing the shelf supports
Install the shelf supports in the opposite
sequence.
The rounded ends of the shelf
supports must point to the front.
9.2 Pyrolysis
WARNING!
The appliance becomes very hot.
There is a risk of burns.
2
Stainless steel or aluminium
appliances:
Clean the oven door with a wet
sponge only. Dry it with a soft
cloth.
Do not use steel wool, acids or
abrasive materials, as they can
cause damage to the oven sur-
face. Clean the oven control panel
with the same precautions.
9.1 Shelf supports
You can remove the shelf supports to
clean the side walls.
1. Pull the front of the shelf support away
from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
CAUTION!
If a hob is installed with the appli-
ance, do not use it at the same
times as the Pyrolysis function. It
can cause damage to the appli-
ance.
1.
Remove the removable shelf supports
(if applicable) and accessories from
the appliance. Refer to "Removing the
shelf supports".
CAUTION!
Do not let the removable shelf
supports stay in the appliance
during the cleaning procedure.
There is a risk of damage.
ENGLISH 19