Problem Chart - Omnitronic PAM-70 Bedienungsanleitung

9. PROBLEM CHART

PROBLEM
No function, the [POWER]
indicator is not lit:
No function in audio player
operation.
The [POWER] indicator
lights, but there is no sound.
The signal source is
distorted.
The PA system's sound is
distorted.
There is too much bass.
Wrong interconnection of the
PA systems.
• The PA system is not switched on. Press the [POWER] switch.
• The rechargeable battery is discharged. In this case, charge the
rechargeable battery until the charging indicator [CHARGE] goes out.
• Remove the respective data carrier and re-insert it.
• The data carrier is not compatible. Try using another data carrier.
• The level controls or the master control are set to the left stop position.
• The microphone, instrument or audio source is not connected properly.
Check the connection.
• The microphone, instrument or audio source is not switched on.
• In case of audio player operation, no data carrier is inserted or the data
carrier inserted does not contain compatible files. The unit only supports the
MP3 format.
• The data carrier is not compatible. Try using another data carrier.
• Try lowering the output volume on your sound source or music instrument.
• Turn back the corresponding level control on the PA system.
• Lower the PA system's main volume level with the [MASTER] control.
• Lower the PA system's main volume level with the [MASTER] control.
• Try adjusting the tone on your sound source to lower the bass level.
This will allow you to play the music louder before distortion occurs.
• Always connect the line output [LINK] of the master system to the line
input [AUX] of the secondary system.
36/39
REMEDY
00072696.DOC, Version 1.1