G&D DP-Vision-CAT Installation Und Bedienung Seite 106

Configuration
How to change the setting of the scancode set:
1. Press Ctrl+Num
2. Select the row
code set of the remote console (at the
Select the row
scancode set of the local console (at the
3. Under Scancode set
2  activates scancode set 2 for PS/2 keyboard inputs
3  activates scancode set 3 for PS/2 keyboard inputs
4. Press F2 to save your settings.
After you turn the KVM extender on again, the keyboard is initialised and the
selected scancode set is applied.
1. Click on KVM Extenders > [All Extenders]
2. Double-click the computer module of the KVM extender you want to con-
figure.
3. Click on the tab
sole (at the
Click on the tab
the remote console (at the
4. Under
Scancode set
activates scancode set 2 for PS/2 keyboard inputs
Set 2
activates scancode set 3 for PS/2 keyboard inputs
Set 3
5. Click to save your changes.
OK
6. Turn the KVM extender off and on again.
After you turn the KVM extender on again, the keyboard is initialised and the
selected scancode set is applied.
38 · G&D DP-Vision-CAT
(default) to open the on-screen display.
Console setup and press
Local console setup
press F8 to select one of the following options:
if you want to adjust the screensaver of the local con-
Local
module).
CPU
Remote > General
CON
select one of the following options:
Enter if you want to adjust the scan-
CON module).
and press Enter if you want to adjust the
CPU module).
on the directory tree.
if you want to adjust the scancode set of
module).