DisplayMode
display
LITECRAFT
TPIX.7 V *.*
<Slave>
Auto Show
<******>
Static
<Dimmer>
Dimmer Mode
<********>
Back Lite
<***>
Information
24
funktion
TPIX.4
V *.**
*.** = softwareversion
Auto
<********>
******** =
<Auto 0>
<Auto 1>
<Auto 2>
<Auto 3>
<Auto 4>
<Auto 5>
<Auto 6>
<Auto 7>
<Auto 8>
Speed
<***>
*** = <0 100>
Dimmer
<***>
*** = <0 255>
Strobe
<***>
*** = <0255>
Dimmer Mode
<********>
******** =
<Off>
<Dimmer 1>
<Dimmer 2>
<Dimmer 3>
BackLite
<***>
*** =
<On>
<10S>
<20S>
<30S>
Auto Test
Fixture Hours
<****H>
**** = fixture hours
Version
V*.**
*.** = software version
IP Adress
<**.***.***.***>
**.***.***.*** = ipadress
shows the software version direct after
switching on the unit
(this messages appears after 3 seconds
automaticly)
unit is in slave mode and is controlled
by external values received by dmxinput
(this menu is only for information no
settings available)
9 preprogrammed chasers available
(deactivation of all preprogrammed
chasers by menu M&S Mode!)
setting speed in 100 steps for the pre
programmed chaser available
(default setting = Show Speed 100)
setting brightness in steps of 256
setting flash rate in steps of 256
setting dimmer curve
Off = dimmer linear
Dimmer 1 = dimmer scurve 1 (slow)
Dimmer 2 = dimmer scurve 2 (medium)
Dimmer 3 = dimmer scurve 3 (fast)
(default setting = Off)
setting automatic switch off for lcd
backlite (permanent on, switch off after
10, 20, 30 seconds)
(default setting = On)
setting automatic test programm
display the fixture hours
display the software version
display the ipadress