Litecraft TPiX.7 Bedienungsanleitung Seite 20

• Cluster Mounting WITHOUT extra accessories
Up to 4 TPiX.7 can be mounted among themselves without
extra accessories. (see figure).
Only use the second backside mounted yoke (long version) for
the mounting on the truss or any other suitable hanging
point plus suitable hooks/clamps approved by the BGV C1 for
this kind of installation.
The second yoke hast o be alligned in the way that the
mounting opening is aligned to the top. (see
The TPiX.7 will be connected among themselves by the use of
the ¼ turn looks.
Use the allen key supplied with the unit to lock the panels in
vertical line. Make sure to turn the ¼ turn locks safely as far
as they will go.
20
NOTE!
The connection elements mounted at the sides of TPiX.7 are
only used for alignment – means the connection of multiple
TPiX.7 together. These connection elements are NOT used for
static loads and cannot be used for mounting of TPiX.7!
Make sure to safe the fixture by a safety chain which is speci-
fied at least with a load limit of 12 times of the fixtures weight.
Only safety chain with approved connective can be used. At-
tach the safety chain to its designated opening and attach it to
figure). the truss system or a similar and safe attachment point. Assure
to close the fasteners as specified.