Display-Mode - Litecraft held slnt ww Bedienungsanleitung

Display-Mode

display
LITECRAFT
V *.*
<**°C>
<Slave Mode>
<No Signal>
<**°C>
<Master Mode>
<No Signal>
DMX Address
<***>
DMX Channel
<****>
Static
Auto Show
<******>
Master/Slave
<******>
Dimmer Mode
18
function
LITECRAFT
V *.**
*.** = software-version
<**°C>
<*** = fixture-temperature
<Slave Mode>
<No Signal>
<**°C>
<*** = fixture-temperature
<Master Mode>
<******>
<******> = Auto programm 1-4
DMX Address
<***>
*** = DMX-adress
Channel
**** =
< 1 Ch>
< 2 Ch>
< 5 Ch>
Dimmer
<***>
*** = 0-255
Strobe
<***>
*** = 0-255
Auto
<********>
******** =
<Auto 1>
<Auto 2>
<Auto 3>
<Auto 4>
<***>
*** = <1-100>
Master/Slave
<******>
****** =
<Master>
<Slave >
Dimmer Mode
<********>
******** =
<Off>
<Dimmer 1>
<Dimmer 2>
<Dimmer 3>
shows the software version direct after switching on
the unit.
(this messages appears after 3 seconds automaticly)
unit is in slave mode and is not receiving dmx-values
by dmx-input
(this menu is only for information - no settings availa-
ble)
unit is in master mode and is playing back one of four
Auto programm
(this menu is only for information - no settings availa-
ble)
display the DMX-adress
( 1 Ch = <001-511>)
( 2 Ch = <001-510>)
( 5 Ch = <001-508>)
(default setting = 1)
setting DMX-channel mode
(description of modes in next chart)
(default setting = 5 Ch)
setting brightness in steps of 256
setting flash rate in steps of 256
4 pre-programmed chasers available
(default setting = Show Speed 100)
setting speed in 100 steps for the pre-programmed
chaser available
(Standard Einstellung = Show Speed 100)
setting working mode
(Master = control without external controller)
(Slave = control with external controller)
(default setting = Slave)
setting dimmer curve
Off = dimmer linear
Dimmer 1 = dimmer s-curve 1 (fast)
Dimmer 2 = dimmer s-curve 2 (medium)
Dimmer 3 = dimmer s-curve 3 (slow)
(default setting = off)