Addressing - EuroLite LED TMH-41 Hypno Bedienungsanleitung

Addressing

The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED TMH-41 Hypno will respond to the controller.
If you set, for example, the address in the 23 channel mode to channel 24, the device will use the channel 24
to 46 for control.
Please, be sure that you don't have any overlapping channels in order to control each LED TMH-41 Hypno
correctly and independently from any other fixture on the DMX-chain.
If several LED TMH-41 Hypno are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the LED
TMH-41 Hypno via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received at the DMX-input, the display will show "A.001", the dot will flash, with the actually set address. If
there is no data received at the DMX-input, the display will show "A001" with the actually set address.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
29/36 00102616, Version 1.0