State" Menu, Display Of Memory State - HomeMatic WDC7000 Bedienungsanleitung

obtain the very latest weather data, enabling you to track the wind direction and wind veloci-
ty trend, for example, for 10 seconds.
As the combination sensor switches to receive data more often when "LIVE MODE" is active,
it consumes more current, which has an adverse effect on battery life. Therefore, the "LIVE
MODE" menu can be used to set a period of time for which "LIVE MODE" will remain active.
During this period the main menu line will also display the "REQ" touch field, which is used to
request the live retrieval of data described above.
- Select the "LIVE MODE" menu:
NEXT
- Touch "ENTER" and the following appears:
BEGIN
- Touch "+" or "-" to set the switch-on time for "LIVE MODE".
- Touch "BEGIN" and the following appears:
END
- Touch "+" or "-" to set the switch-off time for "LIVE MODE".
- Wait for a few seconds. The device will then return to normal mode and the data
that has just been set will become active.
- The menu line indicates that data is being transmitted to the combination sensor
with the message: "WAIT FOR TRANSMISSION". The weather station cannot be
operated for as long as this message is displayed.
- When "LIVE MODE" is active, the menu also displays the "REQ" touch field for
retrieving data:
MIN MAX
4.3.11 „STATE" menu, display of memory state
The utilisation of the internal data memory can be displayed in this menu. The value that is
displayed represents the amount of memory usage in percent.
- Select the „STATE" menu:
NEXT
- Touch „ENTER" and the following appears:
MEMORY USAGE
- The displayed values show the amount of memory usage in percent (e.g. 50%, see above).
LIVE MODE
RESET
STATE
ENTER
+16.00-
+23.45-
REQ
ENTER
CFG
050
65