Connecting Mode" Menu; Cleaning" Menu, Cleaning Mode; Live Mode" Menu, Calling The Current Weather Data Trend - HomeMatic WDC7000 Bedienungsanleitung

4.3.8

"CONNECTING MODE" menu

In connecting mode you can teach-in the internal sensors of the WDC7000 to other WDC7000
stations and to the HomeMatic central control unit. To do this, you must set the corresponding
connection partners and the WDC7000 to teach-in mode.
CONNECTING MODE
- To launch teach-in mode touch "OK" and the following appears:
The WDC7000 is now in teach-in mode. Once the teach-in procedure has been completed suc-
cessfully, teach-in mode and the configuration menu are exited. If no teaching-in is performed
for 20 seconds, teach-in mode and the configuration menu are exited.
4.3.9

"CLEANING" menu, cleaning mode

As the display is touched on a regular basis this can make it dirty, so it must be wi-
ped with a dry linen cloth from time to time (a cleaning cloth for spectacles is ideally
suited to this task; do not use any cleaning fluids as this could damage the display).
To ensure that you do not change any settings on the station when wiping the dis-
play, you can use cleaning mode, which locks all touch fields for 20 seconds.
- Select the "CLEANING" menu:
NEXT
- Touch "ENTER" and the following appears:
CLEANING
- Touch "START" and the following appears:
CLEANING
- You can now clean the display. After 20 s the normal display will reappear.

4.3.10 "LIVE MODE" menu, calling the current weather data trend

In this mode, you can touch an additional field to prompt the combination sensor to send its
measured data at 1 second intervals for 10 seconds. So a single touch is all that is needed to
64
CONNECTING
CLEANING
OK
ENTER
START
WAIT