System" Menu, System Settings; Beep", Activating/Deactivating The Button Tone; Dcf", Activating/Deactivating Dcf-Reception - HomeMatic WDC7000 Bedienungsanleitung

BRIGHT CTRL
- Touch "ON" to toggle between activating (ON) and deactivating (OFF) automatic
lighting control.
- Touch "BRIGHT CTRL" and the following appears:
BEGIN
- Touch "+" or "-" to set the switch-on time for the (continuous) light.
- Touch "BEGIN" and the following appears:
END
- Touch "+" or "-" to set the switch-off time for the (continuous) light.
- Wait for a few seconds. The device will then return to normal mode and the data
that has just been set will become active.
4.3.7

"SYSTEM" menu, system settings

You can use this menu to make settings for the automatic daylight saving adjust-
ment (DST, refer also to the Appendix), for activating the button tone (BEEP), for
activating the radio controlled clock (DCF), for the data logger recording interval
(INTERVAL), for the location height (ALTITUDE), for adjusting the rain sensor (RAIN
CAL) and for configuring the brightness threshold for hours of sunshine (SUN CAL).
Activating/Deactivating the button tone
- Select the "SYSTEM" menu:
NEXT
- Touch "ENTER" and the following appears:
BEEP
- Touch "ON" to toggle between activating (ON) and deactivating (OFF) the button
tone.
Activating/Deactivating DCF-reception
- Select the "SYSTEM" menu then the "DCF" option (via BEEP) and the following
appears:
60
ON
SYSTEM
ON
+16.00-
+23.45-
ENTER