Operation; Charging The Battery Pack; Inserting / Removing The Battery Pack Into / Out Of The Drill / Grinder; Reading Off The Battery Status - Parkside PFBS 9.6 A1 Bedienungs- Und Sicherheitshinweise

Operation

Operation
Q
Never use the device for a purpose for which it was
not intended or with non-original parts / accessories.
The use of tools or accessories other than those rec-
ommended in the operating instructions could lead
to you suffering an injury.

Charging the battery pack

Q
NOTE! A battery pack that has been
unused for a while or never been charged
must be charged before reuse or first use.
The battery pack requires about 3–5 cycles before
it can reach its full charge. The charging process
takes about 180 minutes.
CAUTION! RISK OF INjURY! Always pull
out the mains plug (mains adapter
you insert the battery pack into or take it out of
the charger.
C onnect the adapter
I nsert the battery pack
cradle . This can only be inserted with the
9
correct polarity.
T he LED lights up green whenever the bat-
11
tery pack is in the charging cradle
3 a
the adapter is connected to a mains socket.
10
CAUTION! Do not charge a battery pack for
a second time in close succession. There is a
danger of overcharging the battery pack.
Inserting / removing the
Q
battery pack into / out of the
drill / grinder
Inserting the battery pack:
S et the ON / OFF switch
I nsert the battery pack
until it engages.
Removing the battery pack:
P ressing the battery pack buttons
sides at the same time allows you to remove
the battery pack
3 a
56 GB
) before
10
to a mains socket.
10
into the charging
3 a
and
9
to position "0".
5
into the drill / grinder
3 a
at the
3
.

Reading off the battery status

Q
The status or residual power is indicated as follows
in the battery-operated LED
ance is switched on:
RED / ORANGE / GREEN = maximum charge / power
RED / ORANGE = medium-level charge / power
RED = weak charge – recharge battery
Inserting or replacing
Q
a tool / collet
P ress the spindle lock
R otate the clamping nut
engages.
L oosen the clamping nut
tion key .
23
I f a tool is already inserted, remove it.
F irst insert the tool you wish to use through the
clamping nut before you insert it into the
6
collet suitable for the tool shaft.
18
P ress the spindle lock
I nsert the collet
18
tighten the clamping nut
the combination key
NOTE: Use the screwdriver end of the combi-
nation key to release or tighten the screw of
23
the mandrels .
13
Switching on and off / Setting
Q
the speed range
Switching on / Setting the speed range:
S et the ON / OFF switch
S et the rotational speed control
between „1" and „MAX.".
Switching off:
S et the ON / OFF switch
Advice on working with
Q
materials / Tools / Speed ranges
U se the highest speed when working on steel
or iron with the milling bits.
whenever the appli-
2
and keep it pressed.
8
until the lock
6
with the combina-
6
and keep it pressed.
8
into the threaded insert and
on the thread using
6
.
23
to position "I".
5
to a position
1
to position "0".
5