Eurolite Ir-7 Remote Control - EuroLite LED SLS-603 TCL + UVFloor Bedienungsanleitung

2
Strobe
3
Programs via DMX
4
Speed via DMX
8 channel mode
Channel:
1
2
3
4
5
Dimmer
6
Strobe
7
Programs via DMX
8
Speed via DMX

EUROLITE IR-7 remote control

230 - 239 Red + Blue + UV
240 - 249 Green + Blue + UV
250 - 255 Red + Green + Blue + UV
000 - 009 No function
010 - 255 Strobe with increasing speed
000 - 009 No function
010 - 199 Auto mode via DMX
200 - 255 Sound mode via DMX
000 - 255 Increasing speed in Auto /Sound modes via DMX
Value: Function:
000 - 255 Red
000 - 255 Green
000 - 255 Blue
000 - 255 UV
000 - 255 Increasing brightness 0 – 100 %
000 - 009 No function
010 - 255 Strobe with increasing speed
000 - 009 No function
010 - 199 Auto mode via DMX
200 - 255 Sound mode via DMX
000 - 255 Increasing speed in Auto /Sound modes via DMX
1
The device must be activated for remote control. For this,
under menu item "InFr", press the ENTER button to confirm
activation.
2
When actuating a button, always hold the remote control in the
direction of the sensor. There must be visual connection
between the remote control and the sensor.
3
The remote control is supplied with a battery inserted. An
insulating foil between the battery and the battery contacts
prevents the battery from being discharged during storage.
Prior to the first operation remove the foil from the battery
support on the rear side of the remote
control. Otherwise operation of the remote
control is not possible.
4
If the range of the remote control decreases
(10 meters as a maximum), replace the battery. For this
purpose, on the rear side of the remote control press the small
bar with the groove to the right and at the same time remove
the battery support. For operation, one 3 V button cell type CR
2025 is required. When inserting, pay attention that the
positive pole of the button cell shows upwards in the support.
25/27 00095594, Version 1.0