Eurolite Ir-7 Remote Control - EuroLite LED SLS-6 UV Floor Bedienungsanleitung

EUROLITE IR-7 remote control

Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and should
No. Key (Step 1)
1 BLACKOUT
2 AUTO
3 SOUND
4 STROBE
5 SPEED
6 SENSITIVITY
7 DMX/%
8 MANUAL
9 FADE
10 Number: 1-9
1
The device must be activated for remote control. For this,
under menu item "InFr", press the ENTER button to confirm
activation.
2
When actuating a button, always hold the remote control in
the direction of the sensor. There must be visual connection
between the remote control and the sensor.
3
The remote control is supplied with a battery inserted. An
insulating foil between the battery and the battery contacts
prevents the battery from being discharged during storage.
Prior to the first operation remove the foil from the battery
support on the rear side of the remote
control. Otherwise operation of the remote
control is not possible.
4
If the range of the remote control decreases
(10 meters as a maximum), replace the battery. For this
purpose, on the rear side of the remote control press the
small bar with the groove to the right and at the same time
remove the battery support. For operation, one 3 V button
cell type CR 2025 is required. When inserting, pay attention
that the positive pole of the button cell shows upwards in the
support.
CAUTION!
not be disposed of with regular domestic waste!
Step 2 Description
Blackout
+/- Internal programs
+/- Sound controlled internal programs
+/- Strobe effect - available for AUTO / SOUND programs
+/- Select the desired speed for AUTO / SOUND programs
+/- Microphone sensitivity
Enables or disables DMX mode on the device
Choose UV
+/- Adjust brightness manually
Fading (on or off) for AUTO / SOUND / MANUAL programs
Adjust brightness for AUTO / SOUND / MANUAL programs
25/27 00095600, Version 1.0