Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EUROLITE IR-13 remote control
1
2
3
groove to the right and at the same time remove the battery support. For operation, one 3 V button cell
type CR2032 is required. When inserting, pay attention that the positive pole of the button cell shows
upwards in the support.
Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and should
Control via IR remote
The Controller has several buttons with following functions:
Brightness up
Red
100% R + 24% G
100% R + 47% G
100% R + 71% G
100% R + 100% G
The device features a memory function. The last program selected will begin anew when the device is
restarted.
DMX-controlled operation
You can control the device individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.
When actuating a button, always hold the remote control in the direction of the
sensor. There must be visual connection between the remote control and the
sensor.
The remote control is supplied with a battery inserted. An insulating foil between the
battery and the battery contacts prevents the battery from being discharged during
storage. Prior to the first operation remove the foil from the battery support on the
rear side of the remote control. Otherwise operation of the remote control is not
possible.
If the range of the remote control decreases (10 meters as
a maximum), replace the battery. For this purpose, on the
rear side of the remote control press the small bar with the
not be disposed of with regular domestic waste!
Brightness down
Green
90% G + 23% B
82% G + 46% B
72% G + 69% B
100% G + 100% B
CAUTION!
OFF
Blue
22% R + 87% B
48% R + 75% B
67% R + 62% B
100% R + 100% B
37/48
ON
White
50% / 100% power
Strobe effect
Color Fading
Color Switching
00112598.DOC, Version 1.0
Werbung
Inhaltsverzeichnis
