Herunterladen Inhalt Inhalt Diese Seite drucken

Eurolite Ir-13 Remote Control - EuroLite AKKU UP-4 QCL Spot QuickDMX Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für AKKU UP-4 QCL Spot QuickDMX:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

bL--
b000-b255
UL--
U000-U255
SoUA
SO.UA
LEd
on/off
nodE
nod0-nod4
UErn
UEX.X
POU-
PO-1/PO-2

EUROLITE IR-13 remote control

1
2
3
groove to the right and at the same time remove the battery support. For operation, one 3 V button cell
type CR2032 is required. When inserting, pay attention that the positive pole of the button cell shows
upwards in the support.
Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and should
Control via IR remote
The Controller has several buttons with following functions:
Brightness up
Red
100% R + 24% G
100% R + 47% G
100% R + 71% G
100% R + 100% G
The device features a memory function. The last program selected will begin anew when the device is
restarted.
Dimmer intensity of blue LED color
000 – 255 (increasing)
Dimmer intensity of white LED color
000 – 255 (increasing)
Sound controlled mode
Display shutoff
on – display always on
off – shuts off the display after about 2 minutes
Dimmer speed (step response)
node0: Response characteristics of LEDs
node1: Response characteristics of halogen lamps, fast
node2: Response characteristics of halogen lamps, less fast
node3: Response characteristics of halogen lamps, middle
node4: Response characteristics of halogen lamps, slow
Software version
Power-save mode
PO-1 - power save mode, 50 % power
PO-2 - full power
When actuating a button, always hold the remote control in the direction of the
sensor. There must be visual connection between the remote control and the
sensor.
The remote control is supplied with a battery inserted. An insulating foil between the
battery and the battery contacts prevents the battery from being discharged during
storage. Prior to the first operation remove the foil from the battery support on the
rear side of the remote control. Otherwise operation of the remote control is not
possible.
If the range of the remote control decreases (10 meters as
a maximum), replace the battery. For this purpose, on the
rear side of the remote control press the small bar with the
not be disposed of with regular domestic waste!
Brightness down
Green
90% G + 23% B
82% G + 46% B
72% G + 69% B
100% G + 100% B
CAUTION!
OFF
Blue
22% R + 87% B
48% R + 75% B
67% R + 62% B
100% R + 100% B
36/44
ON
White
50% / 100% power
Strobe effect
Color Fading
Color Switching
00096586.DOC, Version 1.1

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis