Cleaning And Maintenance; Replacing The Fuse - EuroLite LED SLS-603 TCL + UVFloor Bedienungsanleitung

Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and should
No. Key (Step 1)
1 BLACKOUT
2 AUTO
3 SOUND
4 STROBE
5 SPEED
6 SENSITIVITY
7 DMX/%
8 MANUAL
9 FADE
10 Number: 1-9

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse-holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse-holder.
Step 3: Install the new fuse in the fuse-holder.
Step 4: Replace the fuse-holder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.
CAUTION!
not be disposed of with regular domestic waste!
Step 2 Description
Blackout
+/- Internal programs
+/- Sound controlled internal programs
+/- Strobe effect - available for AUTO / SOUND programs
+/-
Select the desired speed for AUTO / SOUND programs
+/- Microphone sensitivity
Enables or disables DMX mode on the device
Choose R/G/B
+/- Adjust brightness manually
Fading (on or off) for AUTO / SOUND / MANUAL programs
Adjust brightness for AUTO / SOUND / MANUAL programs
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
26/27 00095594, Version 1.0