Eurolite Ir-4 Remote Control - EuroLite LED SLS-144 RGBW -144 RGBW FloorSpot Bedienungsanleitung

4-channel mode
Channel: Value:
1 000 – 255
Channel: Value:
2 000 – 255
Channel: Value:
3 000 – 255
Channel: Value:
4 000 – 255

EUROLITE IR-4 remote control

1
The device must be activated for remote control. For this, hold the remote control in the direction of
the sensor and press the ON button. If the LED SLS-144 RGBW Floor receives data from the IR
remote control correctly, the LED display will flash once.
2
When actuating a button, always hold the remote control in the direction of the sensor. There must be
visual connection between the remote control and the sensor.
3
The remote control is supplied with batteries inserted. An insulating foil between the batteries and the
battery contacts prevents the batteries from being discharged during storage. Prior to the first
operation remove the foil from the battery support on the rear side of the remote control. Otherwise
operation of the remote control is not possible.
4
If the range of the remote control decreases (8 meters as a maximum), replace the batteries. For this
purpose, on the rear side of the remote control press the small bar with the
groove to the right and at the same time remove the battery support. For
operation, two 1.5 V button cell type AG10 are required. When inserting, pay
attention that the positive pole of the button cells shows upwards in the
support.
Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and should
Button
ON
OFF
Red
Green
Blue
White (U)
JUMP
FREEZE
DIMMER +
FADE
DIMMER -
SPEED +
REVE
SPEED -
FLASH +
FLASH
FLASH -
COLOR PRESETS
SOUND
SLAVE
Function:
Red (0 – 100%)
Function:
Green (0 – 100%)
Function:
Blue (0 – 100%)
Function:
White (0 – 100%)
CAUTION!
not be disposed of with regular domestic waste!
Power ON
Power OFF
Brightness control via "Dimmer +" or "Dimmer -"
Brightness control via "Dimmer +" or "Dimmer -"
Brightness control via "Dimmer +" or "Dimmer -"
Brightness control via "Dimmer +" or "Dimmer -"
Endless loop in 15 colors, speed control via "Speed +" or "Speed -"
Run or stop " Jump " or " Fade " programs
Increase Color Brightness by 65 steps: b-00 – b-64
Fade, speed control via "Speed +" or "Speed -"
Decrease Color Brightness by 65 steps: b-64 – b-00
Increase speed by 16 steps: P-00 – P-15 for Jump/Fade programs
Optional 15 static colors, decreasing value C14 - C00
Decrease speed by 16 steps: P-15 – P-00 for Jump/Fade programs
Increase Flash speed by 16 steps: F-00 - F15
Flash/Strobe on or off
Decrease Flash speed by 16 steps: F-15 - F-00
Optional 15 static colors, increasing value, C00 - C14
Endless loop in 15 colors via sound control
Set Slave Mode on Slave devices
Function
23/24 00076701.DOC, Version 2.0