Setting Date And Time (Dat) - eQ-3 MAX! Wandthermostat+ Bedienungsanleitung

2. Installed condition
Once mounted, the MAX! wall thermos-
tat can easily be pulled out of the frame.
• Pull the wall thermostat (C) off the wall
together with the frame by pulling side-
ways at the frame.
Change batteries
• Turn the wall thermostat (C) over to remove or insert the
batteries according to the illustration. After removing the
old batteries, please wait approx. 60 seconds before in-
serting the new ones.
• You can now enter two LR03 batteries (Micro/AAA) into
the battery compartment, making sure they are the right
way round according to the drawings
• Put the MAX! wall thermostat (C) back into the frame (B).
An empty battery symbol (
teries need to be replaced. If, in addition, a V or S are
displayed, the batteries of a taught-in Heating Ther-
mostat (V) or Window Sensor (S) have to be replaced.
Never recharge standard batteries. Doing so will pre-
sent a risk of explosion. Do not throw the batteries
into a fire. Do not short-circuit batteries.
After inserting or replacing batteries the firmware version
number will be shown briefly. Accordingly, date and time will
be requested automatically. Settings can be changed with
the (+) and (-) buttons and confirmed with the OK button.

7. Setting date and time (dAt)

) indicates that the bat-
35