eQ-3 MAX! Wandthermostat+ Bedienungsanleitung Seite 54

tion about taught-in devices.
Before you reset the MAX! wall thermostat to the fac-
tory settings, first delete the device from the MAX!
software when operating with the MAX! Cube.
Before you teach-in a single room solution with a
MAX! Wall Thermostat + to a MAX! Cube, you must
reset all devices to the initial state.
• Press the Menu button for more than 3 seconds.
• Select the "rES" menu item with the (+) and (-) buttons.
• Confirm the setting with the OK button.
• The display will show "ACC", confirm restored factory
settings with the OK button.
If a room control unit is taught-in to the MAX! LAN
Gateway the configuration menu on the device will
be locked. You can still restore the factory settings:
• Remove a battery and wait for 60 seconds.
• Press and hold down reduce ( ), OK and the - button
simultaneously and insert the battery at the same time
• When „rES" appears on the display, the reset was per-
formed and the buttons can be released.
• You can now start to make the setting.
54