Adhesive strip mounting:
• Choose a site for installation. The surface on which you
are mounting the MAX! Wall Thermostat + must be clean,
dry and greaseless.
• For mounting of the assembled MAX! Wall Thermostat + ,
attach the adhesive strips to the back side of the moun-
ting plate. You should be able to read the letters on the
back side (according to figure).
• Remove the protective film from the adhesive strip.
• Press the assembled MAX! Wall Thermostat + with the
back side to the wall in the position where it should sub-
sequently be attached.
Screw mounting:
• Choose a site for installation.
Make sure that electrical lines in the wall will not be
damaged.
• Position the mounting plate on the desired site on the
wall. Make sure that the arrow on the mounting plate is
pointing upwards.
<PA66>
37