Insert Batteries - REVELL katamaran BARRACUDA Bedienungsanleitung

1. Remove the cover in the
direction indicated by the
arrow.
caution: Always follow the instructions when charging the battery. The battery must be allowed to cool down for approximately 15 to 30 minutes
before charging and after each drive. Otherwise, the battery may become damaged. The charging process must be continuously super­
vised. Make sure that the surface and environment is flameproof for the charging process.
1. Remove the casing
5. Fit the cabin on the boat again. If you
want to drive the boat immediately,
switch on your remote control and switch
the ON/OFF switch to ON, then connect
the battery.
1. gettINg StArteD:
Fig. 1
8

Insert Batteries

2. Insert four 1.5 V AA batteries according to
the polarity in the battery compartment.
charging the boat battery
2. Switch off the boat and remote control,
remove the battery from the boat.
After a charging time of 180 minutes, the boat can drive approx. 5-10 minutes.
Warning:
Check the battery for damages or deformation before each charging process.
Do not continue to use damaged batteries and dispose of them correctly. Please stop
immediately if the battery becomes too hot during charging or the charging process
does not run correctly!
3. Close the battery
compartment cover
3. Plug the charger into a socket and con­
nect the battery with the charger. The LED
on the charger lights red. When the charg­
ing process is complete, the LED turns
green, then disconnect the battery from
the charger and unplug the charger.
Drive boat
Before starting, make sure that the trim controllers for speed and steering
Fig. 2
(TH. TRIM and ST. TRIM) are in the middle position.
Pay attention to the sequence when switching on: set the ON/OFF switch on the side of
the remote control to "ON" (fig. 1). Both power LEDs on the remote control
light red and green in the full charge. Then set the ON/OFF switch of the speed boat to
"ON" (fig. 2).
Set your boat down in the water where the water is at least 0.2 deep. Make sure that grass,
sticks and refuse are not floating in the water. Direct the boat so that the bow is pointing
towards you. Gently push the boat so that it is a safe distance from the bank. Regulate the
trim controller for steering (ST. TRIM) on your remote control until the boat drive straight
ahead with the steering in neutral. Start driving by slowly pulling the speed controller
towards you.
caution! If the boat becomes slower, you should immediately return to the bank
because the motor is switched off when the battery is drained to avoid damage
caused by deep discharge.
compulsory: when switching off the vehicle and remote control, the ON/OFF switch on
the speed boat to "OFF". The switch the ON/OFF switch on the radio remote control to "OFF"
(compare fig. 2). Otherwise an unintentional drive command can be given
so the speed boat independently drives off, leading to significant damages.
4. Green and red power LEDs on the remote
control indicate: fully charged.
4. Insert the battery in the boat, but do
not connect it!