Handling; Maintenance - Renkforce GM107 Bedienungsanleitung

12. Handling

• Never connect the mains plug to a mains socket immediately after the device has been taken from a cold
to a warm environment. The resulting condensation may destroy the device. Allow the device to reach
room temperature before connecting it. Wait until the condensation has evaporated.
• Never pull the mains plug from the mains socket by the cable. Only pull it from the mains socket by the
intended grip areas.
• Always pull it from the socket using the intended grips.
• Disconnect the mains plug from the mains socket during thunderstorms for reasons of safety.
• Never put any filter foils, masks or other materials over the light exit. This may cause heat damage and
danger of fire.
• The device may heat up during operation. Never touch the casing during operation. Let the effect light
cool off after operation before touching or cleaning the casing.
• Do not cover the device to ensure sufficient ventilation. Air circulation also must not be impaired by any
objects like magazines, tablecloths, curtains, etc. During operation, keep a minimum distance of 0,5 m
around the device.

13. Maintenance

Regularly check the technical safety of the effect beamer, e.g. for damage to the mains cable or the ca-
sing.
If you have reason to believe that the device can no longer be operated safely, disconnect it immediately
and make sure it is not operated unintentionally. Pull the mains plug from the mains socket!
It can be assumed that safe operation is no longer possible if:
• the device is visibly damaged
• the device is longer working
• the device has been stored under unfavourable conditions for an extended period of time or
• the device has been subjected to heavy stress during transport.
Always observe the following safety instructions before cleaning or servicing the effect beamer:
Live components may be exposed if covers are opened or components are removed.
The device must be disconnected from all power sources before any servicing or repair work is
carried out.
Capacitors inside the device may still carry voltage even though they have been disconnected
from all power sources.
Only qualified experts familiar with the hazards involved and the relevant regulations must per-
form repairs.
3