Temperature Display; K) Reset; L) Focussing; Handling - Renkforce GM106NS LED Bedienungsanleitung

j) Temperature Display
• Push the button MENU (2) until "tenp" is displayed and push the button ENTER (5).
• The display shows the internal device temperature.

k) Reset

• Push the button MENU (2) until "rSet" is displayed and push the button ENTER (5).
• The device performs a reset. During this time, the software version is displayed.
• After a successful reset, operation will recommence in the last operating mode.

l) Focussing

• Adjust the sharpness of the projection as desired by turning the projection lens at the lens.

12. Handling

• Never connect the mains plug to a mains socket immediately after the device has been taken from a cold
to a warm environment. The resulting condensation may destroy the device. Allow the device to reach
room temperature before connecting it. Wait until the condensation has evaporated.
• Never plug in or unplug the mains plug when your hands are wet.
• Never pull the mains plug from the mains socket by the cable. Only pull it from the mains socket by the
intended grip areas.
• Unplug the mains plug from the mains socket if you are not using the device for an extended period of
time.
• Disconnect the mains plug from the mains socket during thunderstorms for reasons of safety.
• Do not cover the device to ensure sufficient ventilation. Air circulation and the movement of the projector
head must not be impaired by objects such as magazines, tablecloths, curtains, etc. During operation,
keep a minimum distance of 0.5 m around the device.
42