Fuse Replacement; Handling - Renkforce LV-DJ13 Bedienungsanleitung

b) Fuse replacement
If you have to replace the fuse, ensure that you only use fuses of the specified type and rated current (see "Technical
data") as a replacement
Never repair fuses or bridge the fuse holder.
• Unplug the mains plug from the mains socket and the low-voltage line from the mains connection on the device.
• Using a suitable screwdriver, carefully push the fuse holder at the mains connection.
• Remove the defective fuse and replace it with a new fuse of the indicated type.
• Carefully push the fuse holder with the new fuse back into its position at the mains connection of the device.
• After this, you can reconnect the device to the mains and take it into operation.

12. Handling

• Never connect the mains plug to a mains socket immediately after the device has been taken from a cold to a warm
environment. The resulting condensation may destroy the device.
Allow the device to reach room temperature before connecting it. Wait until the condensation has evaporated.
• Never pull the mains plug from the mains socket by the cable. Only pull it from the mains socket by the intended
grip areas.
• Always pull it from the socket using the intended grips.
• Disconnect the mains plug from the mains socket during thunderstorms for reasons of safety.
• Never put any filter foils, masks or other materials over the light exit. This may cause heat damage and danger of
fire.
• The device may heat up during operation. Never touch the casing during operation. Let the effect light cool off after
operation before touching or cleaning the casing.
• Do not cover the device to ensure sufficient ventilation. Air circulation also must not be impaired by any objects
like magazines, tablecloths, curtains, etc. During operation, keep a minimum distance of 0.5 m around the device.
25