Self-Check Program - JVC DT-V9L5 Bedienungsanleitung

Self-check program

This monitor has a self-check function, which allows it to detect malfunctions and alert you. This makes troubleshooting easier. Whenever a
problem occurs, one or some of the INPUT SELECT lamps will flash. If this happens, follow the steps below and contact your dealer to resolve the
problem.
When the screen goes blank, and one or some of the INPUT SELECT lamps (SDI 1/SDI 2) on the front control panel start flashing...
1
Check which lamps are flashing.
2
Press button to turn off (on standby) the monitor.
3
Turn off the power switch and DC switch on the rear panel.
4
When the AC power supply is used: Disconnect the AC power cord from the AC outlet.
When a DC power supply is used: Detach the battery or disconnect the plug from the DC IN terminal.
5
Contact your dealer with the information about which lamps were flashing.
●
If you turn on the monitor soon after turning it off (or after a short-term power failure), the INPUT SELECT lamps may flash and no image may
be displayed.
When this happens, turn off power and wait at least 10 seconds before turning on the monitor again.
If the INPUT SELECT lamps do not flash, you can use the monitor as normal.
●
The self-check function does not work when the setup menu "Remote Active On Standby" is set to "Off" and you turn off the monitor (put the
monitor in standby).
INPUT
SCOPE HDMI
EN EN
27