Index Of Parts And Functions; Rear Panel - JVC DT-V9L5 Bedienungsanleitung

Index of Parts and Functions

Rear panel

Carry handle
Use this handle when carrying the monitor.
1 POWER switch
Turns AC power on or off.
button (☞ q on page 10) to use the monitor after turning on the POWER switch.
●
You need to press
2 AC IN terminal
AC power input connector.
Connect the provided AC power cord to an AC outlet.
●
Attach the provided power cord holder to prevent accidental disconnection of the AC power cord (☞ "Attaching the power cord holder"
on page 9).
CAUTION
Do not connect the power cord until all other connections are completed.
3 DC switch
Turns the DC power on or off.
button (☞ q on page 10) on the front panel to turn on the monitor after turning on the DC switch.
●
You need to press
●
The monitor consumes the battery even while the monitor is on standby. To save battery life, turn off the DC switch.
4 DC IN terminal
DC 12 V (maximum DC 17 V) power input connector.
When using DC 12 V power (maximum DC 17 V), check the DC IN terminal pin signal, and use the correct polarity. If the polarity is
reversed, this could cause a fire or personal injury.
●
While using both the AC and DC power supply, AC power supply is preferentially used. If the AC power supply is cut off (for example, when
turning off the POWER switch), the power supply automatically switches to the DC power supply.
●
Use a DC power supply with the LPS (Limited Power Sources) function.
5 VIDEO/COMPONENT terminals (BNC)
IN: Input terminals for the composite (VBS) and the analog component (Y/P
Select the signal type in "Video/Component Select" corresponding to the type of the input signal (☞ page 15).
OUT: Output terminal for the composite (VBS) and the analog component (Y) signals.
6 AUDIO (IN) terminal (pin jack)
Input terminal for the analog audio signals.
●
Use this terminal for the analog audio connection of the SDI. To select the audio output, set in "Audio Setting" of the Main Menu.
●
When you use HDMI input for the picture and analog sound for the audio signal, input analog sound into this terminal, and set in "Audio
Setting" of the Main Menu. (☞ page 16)
8
Security slot
Attach a security wire to this slot.
/P ) signals.
B R