Technical Data - LumaSense Technologies IGA 320/23 Betriebsanleitung

IMPAC pyrometer IGA 320/23
1

Technical data

Temperature ranges:
Sub range:
Spectral range:
IR detector:
Power supply:
Power consumption:
Analog output:
Load:
Switch contact:
Hysteresis:
Digital Interface:
Resolution:
Isolation:
Parameters:
Emissivity ε:
Transmittance :
Exposure time t :
90
Maximum / minimum
value storage:
Uncertainty:
(with ε =1, t =1 s, T =23°C)
90 amb.
Repeatability:
(ε =1, t =1 s, T =23°C)
90 amb.
Protection class:
Ambient temperature:
Storage temperature:
Rel. humidity:
Weight:
Housing:
Connector:
Dimensions [mm]:
Sighting:
CE-label:
75 ... 550°C (MB 5.5)
100 ... 700°C (MB 7)
any range adjustable within the temperature range
minimum span 51°C
2 to 2.6 µm (main wavelength 2.3 µm)
Extended InGaAs
24 V DC (10 to 30 V DC), ripple must be less than 0.5 V
Max. 1 W
0 to 20 mA or 4 to 20 mA (linear), switchable
0 to 500 Ω
Opto relays; max. 50 V DC, 0.2 A; max. P
2 to 20°C
RS485 addressable (half duplex), baud rate 1200 up to 38400 Bd
0.1°C on interface;
< 0.025% of the adjusted temperature sub range at the analog output
power supply, analog output and digital interface are galvanically isolated from
each other
Adjustable via interface:
Emissivity ε, transmittance , exposure time t
storage or automatically deletion of max. / min. value storage, analog output
0 - 20 or 4 - 20 mA (switchable), sub temperature range, ambient temperature
compensation, address, switch contact, hysteresis, baud rate, wait time t
10.0 to 100.0% adjustable via interface in steps of 0.1%
10.0 to 100.0% adjustable via interface in steps of 0.1%
2 ms (with dynamical adaptation at low signal levels);
adjustable to 0.01 s; 0.05 s; 0.25 s; 1 s; 3 s; 10 s
Built-in single or double storage. Clearing with adjusted time t
0.05 s; 0.25 s; 1 s; 5 s; 25 s), via interface or automatically with the next meas-
uring object
up to 400°C: 2°C
above 400°C: 0.3% of measured value in °C + 1°C
above 1500°C: 0.5% of measured value in °C
(Note: the pyrometer must be operate at least 30 min before these values are valid)
0.1% of measured value in °C + 1°C
IP65 (IEC 60529)
0 to 70°C on housing, T
-20 to 70°C
No condensing conditions
0.3 kg
Stainless steel
8 pin connector
Built-in LED targeting light
According to EU directives about electromagnetic immunity
150 ... 1200°C (MB 12)
200 ... 1800°C (MB 18)
= 300 mW
max
, clear times for max. / min. value
90
at least 25°C above T
meas.
W
(off; 0.01 s;
clear
housing
5