Safety Instructions - VOLTCRAFT VC-5080 Bedienungsanleitung

6. SAFETY INSTRUCTIONS

Please read the operating instructions thoroughly before use, they contain important information
on correct operation.
In case of damage caused by non-observance of these operating instructions, the warranty gets
void! We are not liable for any consequential damage!
We are not liable for property damage or injuries caused by improper use or non-observance of
safety instructions! Such circumstances will void the warranty!
The device left the factory in a safe and perfectly working technical condition.
To maintain this condition and ensure safe operation, the user must observe all safety instructions and warnings
included in this manual.
Please observe the following symbols:
Please follow the important information in these operating instructions indicated by the symbol with the
exclamation mark in the triangle.
A lightning symbol in the triangle warns against electric shock or impairing the electronic safety of the
device.
The "Arrow" symbol indicates special tips and information about operation.
This device is CE compliant and fulfills all applicable European guidelines.
Protection class 2 (double or reinforced insulation, protective insulation).
CAT I
Measuring category I for measurements on electric and electronic devices, which are not directly supplied
with mains voltage(e.g. battery operated devices, protective extra low voltage, signal and control voltages
etc.)
CAT II Measuring category II for measurements at electric and electronic devices, which are directly supplied
with mains voltage via a power plug. This category also includes all smaller categories (e.g. CAT I for
measuring signal and control voltages).
CAT III Measuring category III for measurements in the building installation (e.g. power plugs or sub-distribu-
tors). This category includes all lower categories (i.e. CAT II for measurements on electrical devices).
Measurement operation in CAT III is permissible only using test leads with a maximum exposed contact
length of 4 mm or test leads with protective caps.
CAT IV
Measuring category IV for measurements at the source of the low voltage installation (e.g. main distribu-
tor, house interconnection points of the energy supplier etc.) and outdoors (e.g. work on earth cables,
overhead lines etc.). This category includes all lower categories. Measurement operation in CAT IV is
permissible only using test leads with a maximum exposed contact length of 4 mm or test leads with
protective caps.
Earthing potential
30