Herunterladen Inhalt Inhalt Diese Seite drucken

Topcom cleo Bedienungsanleitung Seite 24

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Cleo
Toll Saver
The device picks up after two ringing tones when there are messages recorded on
the answering machine and after 4 ringing tones when there are no messages.
Put down the receiver after the third ringing tone to avoid telephone charges.
Note: When your device is connected after a telephone exchange with short ringing
rythme, you can change them to half ringing tones. For example, your call will be
answered after 1 ringing tone when messages are recorded and after 2 ringing tones
when there are not messages.
Remote message and memo playback
1. Dial your telephone number.
2. Enter the security code after the music and the long beep tone. Press and hold
the button for 2 seconds. The device will confirm by sending out 3 beep tones.
3. While you are hearing the music, the microcassette tape will rewind and play any
messages.
4. Hang up your telephone on hearing two beeps at the end of the last message.
Your answering machine will then automatically reset to receive new messages.
Old messages will be erased by new ones unless they are saved.
Remote saving messages after playback
1. Press "2" within 8 seconds after hearing 2 beeps at the end of the last message.
2. Hang up the phone.
42
Cleo
Remote erasing messages
When you have decided not to save the messages you listened to, the tape will
rewind to start recording new ones. Your old messages will be erased as new mes-
sages are recorded.
Switching to Auto-Answer by Remote Control
1. Dial your telephone number.
2. After 10-12 rings, you will hear 2 BEEPS, followed by a single BEEP .
3. Enter the security code.
4. The OGM will play to confirm that the machine is in AUTO-ANSWER mode.
Changing the OGM by remote control
Listen to all ICMS before your record a new OGM.
1. Dial your telephone number.
2. Enter the security code after the music and the long beep tone.
3. Press within the next 3 seconds on "2" when you hear 3 beep tones.
4. Dictate your new OGM after hearing a single beep tone.
5. Press "2" when you have completed your new OGM.
6. Your new OGM will be played automatically for your checking.
7. Hang up the handset if your new OGM is acceptable.
43

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis