Memory - Topcom cleo Bedienungsanleitung

Cleo
FLASH Button
(14)
With the FLASH button you can put through a conversation by means of an
(14)
interruption of the line, provided that the telephone is connected to a PABX switch-
board.
MEMOR Y
Storing a Telephone Number
This telephone can store up to 13 telephone numbers. Each of the memory number
locations can store up to a maximum of 15 digits. The numbers can be stored in
either tone or pulse mode.
Storing Direct Numbers
The M1, M2 and M3 buttons are direct memory locations for the numbers you
(25)
use the most.
1. Pick up the handset and wait for the dial tone.
2. Press and release the STORE button
3. Dial the telephone number to be stored.
4. Press and release the STORE button
5. Press the memory button (M1, M2 or M3)
number.
6. Replace the handset in its cradle.
Dialling Direct Numbers
1. Pick up the handset and wait for the dial tone.
2. Press the direct memory button M1, M2 or M3
ber you want to dial is stored. The unit will dial the number automatically.
36
.
(12)
again.
(12)
under which you want to store the
(25)
in which the telephone num-
(25)
Cleo
Storing Indirect Numbers
Ten additional numbers can be stored in memory and retrieved using the AUTO but-
ton and the numbers on the keypad.
(10)
1. Pick up the handset and wait for the dial tone.
2. Press and release the STORE button
3. Dial the telephone number to be stored. If it is a long distance number, be sure
to add the international code and the land code, followed by the area code (with-
out 0) and the subscriber's number. If it is a local number, simply dial the digits
of the subscriber's number, without the area code.
4. Press and release the STORE button
5. Press the button on the keypad in which you want to store the number. If you
select button "5" the number will be stored in memory location 5 of the keypad.
6. Return the handset to the cradle.
Repeat steps 1 to 6 to store other telephone numbers in other memory locations.
Note: In case you want to change a number that was stored in a certain memory
location, simply repeat the above steps from 1 to 6 to store a new number. The old
number will automatically be replaced by the new number.
Dialling Indirect Numbers
1. Pick up the handset and wait for the dial tone.
2. Press the AUTO button then press the memory location number in which
(10)
the telephone number you want to dial is stored. The unit will automatically dial
the number stored in the memory button you selected.
37
.
(12)
.
(12)