Adjusting The Receiver Volume; Redial Facility; Keypad Lock; Range Information - switel CD727 Bedienungsanleitung

4.8

Adjusting the receiver volume

If the receiver volume is too quiet or too loud for you, you can change this to suit your requirements.
You can adjust the volume during a call by means of the cursor. The selected volume will be shown in the
display.
4.9

Redial facility

You can use the redial facility if the person called is engaged or does not reply. Your telephone remembers
the last 20 numbers dialled.
Press the up cursor button once.
Up to 20 numbers last dialled can now be selected with the up and down cursor buttons.
Press the call button
4.10

Keypad lock

If you frequently carry the mobile unit with you, you can lock the keypad so that buttons are not pressed
unintentionally. When the keypad lock is switched on, incoming calls can be received as normal.
Activating the keypad lock
Press and hold the # button on the mobile unit for one second.
Deactivating the keypad lock
To deactivate the keypad lock, press the UNLOCK display button.
4.11

Range information

The range of the handset is ca. 50 metres in closed rooms and ca. 300 metres outdoors. When there is a
good contact with the base station, the aerial symbol will come on in the display. If you are too far away from
the base station, the aerial symbol will flash. In this case, move nearer to the base station once more, as
otherwise the call will be interrupted.
4.12

Paging from the base station to the handset

If you cannot remember where you have left the handset, press the
hear the handset audible signals for 30 seconds and thus be able to find it again easily. You can cancel the
audible signal prematurely by pressing the STOP display button.
4.13

R signal button

If you have connected your telephone to a private exchange, you can use all the facilities such as call transfer,
automatic recall, etc. The "R" signal button gives you access to these facilities. The FLASH time "100ms"
(factory setting) or "300ms" will be required on a private exchange. You can find out from the dealer from
whom the equipment was purchased whether your telephone will work on your private exchange without any
problems.
You can find out how to change the FLASH time in Chapter 8.2.4.
- Operation -
and the number will be automatically dialled.
button on the base station. You will
69