Setting Up; Safety Information; Check Contents Of Pack; Connecting The Base Station - switel CD727 Bedienungsanleitung

3 Setting up

3.1

Safety Information

NOTE: Before setting up, it is essential that you read the safety information at the beginning of this manual.
3.2

Check contents of pack

The following items are supplied:
one base station
one mobile unit with batteries
one telephone connecting cable
3.3

Connecting the base station

Position the telephone near to your telephone connection socket and to a mains socket.
1. Insert the plug of the power supply into the socket on the underside of the base station and plug the
power supply into a properly installed 230 V mains socket. The plug-in power supply for the base station
must always be connected. For safety reasons, use only the plug-in mains power supply provided.
2. Connect the telephone cable supplied to the telephone socket and the telephone jack on the underside
of the base station. Use only the new telephone cable provided.
3. Run the two cables through the two cable channels to the rear of the base station.
3.4

Fitting/changing batteries

The rechargeable batteries have a stand-by time of max. 100 hours and a maximum talk
time of up to 10 hours. To fit or change the batteries, open the battery compartment cover
and insert the new batteries. Take care to ensure that the polarity is correct and close the
battery compartment cover.
Use only rechargeable batteries, type AAA 2 x 1.2V, 750mAh.
Important note: Place the mobile unit on the base station with the display to the front for at
least 16 hours. The telephone may malfunction if the batteries are not properly charged. The
indicator light on the base station
3.5

Battery capacity

The rechargeable batteries for your telephone have a stand-by time of max. 100 hours at room temperature
and a maximum talk time of up to 10 hours.
The current battery capacity is shown in the display by means of three red lines.
To charge the batteries, place the mobile unit in the base station with the display to the front.
66
- Setting up -
one mains cable
belt clip
one instruction manual
always illuminates when the mobile unit is charged.
+