HBM T40B Montageanleitung Seite 36

Mechanical installation
34
Fig. 5.6 Alignment of the rotor with the stator (without a
reference signal sensor), Option 7, Code S and U
Rotational speed measurement with a sensor for the
reference signal (zero index):
Tilt the stator slightly (see Fig. 5.7, left), so that the
bracket with the sensor head for the reference signal
(zero index) is between the two flanges. Now tip the
stator over the rotor until the antenna ring completely
covers the flange with the transmitter winding (see
Fig. 5.7, right).
Information
If the stator base is already securely installed, you must
remove the upper antenna segment (see steps 1, 3 and
4). Otherwise proceed with the installation as shown in
the photos.
A3452-10.0 T40B