Setup Of Usals Positioner; Satellite Setup - General satellite HD 9300 Bedienungsanleitung

7. INSTALLATIoN
7.3 Antenna setup

7.3.3 Setup of USALS positioner

To direct the aerial towards a satellite:
• Select the satellite to which the motorised
system is required to be adjusted;
• Select the transponder. The scales of level and
quality of signal from that transponder will be
displayed in the bottom part of the screen;
• Set the latitude and longitude of the location of
the motorised system.
To do that:
OK [24] button;
• Depress the
• Enter the value using the
0 ~ 9 [5] in the format of xxx.x;
GREEN button [10], to save the entered value, or EXIT [23] button, to cancel the
• Depress the
changes.
Go to button. The aerial would start positioning towards the satellite. A message would
• Depress the
be displayed on the screen, about the beginning of motion of the aerial;
• On completion of motion of the aerial, the scales of level and quality of signal should indicate some
values. In case if upon completion of motion of the aerial the scales of level and quality of signal indicate
zero values, try to select another transponder;
• To stop the motion of the motorised system, depress the
YELLOW button [22] to move the aerial into the zero position (Go to position 0 command).
• Depress the
The centre of the range of rotation of the motorised system is accepted as the zero position.

7.4 Satellite Setup

The menu Satellite Setup enables to select the
required satellite from the list, add a new one,
delete, and change both the name of satellite
and the information about its orbital position.
This menu also enables to change parameters of
transponders, or add new transponders.
Satellite Name
Satellite Name are listed alphabetically. In the list,
names in Latin are presented first, then names in
other languages.
If the required satellite is not available in the list,
select the item of New (the last line in the list of
satellites), and depress the YELLOW button [22] .
New Satellite would be added in the list of satellites.
To change the name of that satellite, depress the BLUE button [21]. Using the keyboard, enter the required
name. Name of any satellite can also be changed in that way.
NUMERICAL buttons
RED button [11] (Stop command);
81