Complete Set Of Delivery; Front Panel; Rear Panel - General satellite HD 9300 Bedienungsanleitung

1. PrIor To STArTINg THE oPErATIoN

1.2 Complete set of delivery

(see 1, pg. 3)
1. Receiver
2. Remote control
3. Power cells ААА, 1.5 V for remote control (2 pieces)
4. User Manual
5. HDMI connecting cable
NOTE!
Complete set of delivery can vary depending on the region.

1.3 front panel

(see 2, pg. 4)
1. STANDBY BUTTON
Switching-on and switching-off of the Receiver. The button is intended for switching of the Receiver
from standby mode (Stand By) into operating mode and vice versa. The «Stand By» mode indicator (red),
operating mode (yellow), presence of received signal (green).
2. CHANNEL +/- BUTTONS
Buttons for switching between the channels.
3. TV/R BUTTON
Switching between the modes of receiving of TV and radio channels.
4. CHANNEL NUMBER INDICATOR
Indicates the number of the received channel; the process of loading.
5. CARD READER
If you install a smart-card in this slot, you would be granted an access to coded channels.
6. Common Interface SLOT
CI slot for modules of conditional access.
7. USB
USB connector for updating of the Receiver's software.

1.4 rear Panel

(see 3, pg. 4)
1. LNB IN
Connector for connection of the aerial's cable.
2. LNB OUT
Loop output for connection of another Receiver.
3. ETHERNET
Connector intended for connection of Ethernet cable (not active in all modifications).
4. S/PDIF
Digital optical audio output.
58