Antenna Setup - General satellite HD 9300 Bedienungsanleitung

7. INSTALLATIoN
7.2 Manual search of channels
On completion of the search a request would be
displayed on the screen about saving the newly
detected channels with indication of the number
of new channels.
Depressing of the EXIT [23] button during the
search of channels would stop the search; however,
the channels detected by Receiver could be saved.
In case where required enter additional parameters
of search: skip over coded channels, network
search, audio, video and synchronized PID in the
Additional Menu.
Additional
Network search
This function is performed if the information is available in the given transponder in the digital stream
about frequency of another transponder. The search would then be continued in another transponder.
Skip scrambled
Automatic skip of coded channels during search: select Yes, if you want your Receiver to only save
channels with open access in the memory.
Video PID/Audio PID/ PCR PID
The values of the identifier of packets – PID (audio/video/synchronized) can be entered in manual mode.
This mode is used for search of channels from transponders having non-standard parameters.

7.3 Antenna Setup

The Menu screen of Antenna Setup is available in the section of Setup – System settings.
On this screen one can confront special settings of switches, frequencies of the heterodyne, etc., with the
number of antenna.
NOTE!
Each antenna connected to the Receiver (via a switch) should have an individual number in this section of
the Menu.
Using the RED button [11] of the remote control,
it is possible to delete completely all the data of an
aerial along with the channels associated with the
antenna.
To add a new antenna it would be required to add
in the item of Antenna: New, and depress YELLOW
button [22] , then enter the parameters of the new
antenna.
Type of LNB (converter)
Select type of converter (LNB): universal 1,
universal 2, single, dual.
78