General satellite HD 9300 Bedienungsanleitung Seite 66

4. INSTALLATIoN wIzArD
looked through the number of rates, starting from the minimal one, and finishing with the last one stored
in the memory of the Receiver.
NOTE!
In case where Full search, has been selected, then the item of Rates of the stream would be activated. In
that item one could select the rate depending on which the increment of scanning of the frequency range
would be selected. The range of rates can be edited or added manually. To add a new rate select New depress
YELLOW button [22] and enter the value. To edit the already entered value enter a new value to replace the
previous one. To remove the value of the rate from the list use the RED button [11].
The lower portion of the screen contains two graphical scales showing the level of the signal, with the
respective digital representation in conventional percentage.
The upper scale is named Power of Signal. The reading of the said scale corresponds to electrical
parameters of the received signal.
The lower scale is named Quality of Signal and corresponds to the Eb/N0 parameter of digital signal. In
case where necessary, readings of these scales can be used for precise positioning of the antenna.
Move the cursor to Further button and depress OK [24] to proceed to the next step of the Installation
wizard.
Step 5
At this stage of operation the Installation wizard
of the Receiver performs searching of channels.
The channels detected at the moment would be
displayed in two columns: All TV and All Radio.
On completion of the search a message would
appear specifying the number of detected TV
and radio channels. There would be also a request
to acknowledge the saving of the results of the
search.
Select Yes and depress the OK [24] button.
The detected channels would be saved in the
memory of the Receiver and you will move to the
next step of the Installation wizard.
Step 6
This is the final stage of activity of the Installation wizard. Here you are to set the current time and date.
UTC Offset
Here you can set the difference between your time zone and the Universal Coordinated Time.
66