Servo Mode - Metz MECABLITZ 58 AF-2 Nikon Bedienungsanleitung

21.5 Servo mode

The Servo mode is a simple slave mode in which the slave flash unit always
triggers a flash as soon as it receives a light pulse.
Adjustment procedure for servo flash mode
• Select a mode for the camera flash unit without pre-flash.
• Press the
BEEP
Select
on the display.
Remote
FB
• Use the
Set
"Remote". The selected menu item will be highlighted
with a dark bar.
• Press the
sing the
Servo
effect immediately.
Set
• Press the button
returns to the normal display. If the button
pressed, the screen will automatically return to nor-
mal display after 5 s.
Servo
MZoom 35
P1/1
In general, only the manual flash mode
Para Sel
in the SERVO flash mode.
This is automatically selected after switching the
SERVO flash mode on.
144
key repeatedly until "Select" appears
Sel
and keys to select the menu item
button and select "Servo" by pres-
Set
and buttons. The setting will take
repeatedly until the screen
M
is possible
Setting partial lighting or reflector position (MZoom)
• In SERVO mode, press the
until the set partial lighting or reflector position is
shown. By using the
tial lighting (for example 1/8) or reflector position
(for example MZoom 50) can be set.
Wait for all of the flash units involved to become flash-ready.
Once the slave flash unit is flash-ready, its AF measuring beam
king.
Slave groups and remote channels cannot be set in SERVO mode.
Switching Servo flash mode off
• Press repeatedly until "REMOTE" is shown in the screen
Sel
• Press the button and by using the
Set
select the menu item "REMOTE OFF". The selected
menu item will be highlighted with a dark bar. The
setting will take effect immediately.
• Press the button repeatedly until the screen
is not
returns to the normal display. If the button
pressed, the screen will automatically return to nor-
mal display after 5 s.
button repeatedly
Para
+ –
and buttons, the par-
button,
is not
Servo
MZoom 35
P1/64
Para Sel
will start blin-
BEEP
Select
Remote
FB
Set
Remote
OFF
Set