Ttl Fill-In Flash Mode - Metz MECABLITZ 58 AF-2 Nikon Bedienungsanleitung

Setting procedure:
Mode
• Press the
A TTL
LC display.
A
• Set the flash mode
Set
arrows. The flash mode you choose is then highligh-
ted.
The setting takes effect immediately.
F 5.6
TTL
• Press the button
AZoom 35
the normal view. If the button
12 m ISO 200
display will change back to the normal view after
Mode Para Sel
about 5 seconds.
If the shot was properly lit, the correct exposure indica-
tion will flash „OK" for about 3 seconds (see 13).
To test the TTL function with analog cameras, a roll of film has to be in the
camera. Please note whether there are limitations for your camera in
terms of film sensitivity or ISO (i.e., maximum ISO 1000) for TTL flash
operation (see your camera's operating instructions).

5.3 TTL fill-in flash mode

TTL
Fill-in flash BL overcomes troublesome dense shadows for daylight shots
and produces a more balanced exposure between subject and background with
contre-jour shots. The camera's computer-controlled metering system sets the
most suitable combination of shutter speed, aperture and flash output. When
using a camera from Groups C, D and E (see table 1) with a D-AF Nikkor lens,
the distance to the subject is also calculated into the optimal flash performance.
120
Mode button until „Mode" flashes on the
TTL
using the and
to change the display back to
is not pressed, the
Setting procedure:
• Press the Mode button until „Mode" flashes on the
LC display.
TTL
• Set the BL flash mode using the
arrows. The flash mode you choose is then highligh-
ted.
The setting takes effect immediately.
• Press the button to change the display back to
the normal view. If the button
display will change back to the normal view after
about 5 seconds.
If the shot was properly lit, the correct exposure indica-
tion will flash „OK" for about 3 seconds (see 13).
Ensure that the contre-jour light source does not shine directly into the
lens, as this will interfere with the camera's TTL metering system.
Depending on the camera model, the suitable fill-in flash mode will be automa-
TTL
tically activated after BL flash mode has been set:
Group A:
• Automatic fill-in flash mode or matrix-controlled fill-in flash mode
• Either set automatically or manually on the camera (see camera's operating
instructions)
TTL
• Display on flash unit:
• No extra settings are necessary on the flash unit, nor is there any display for
this mode.
Mode
TTL BL A
A
and
F 5.6
TTL
BL
AZoom 35
12 m ISO 200
is not pressed, the
Mode Para
Set
Sel