Cordless Remote Mode (Remote); Meter-Feet Changeover (M/Ft) - Metz MECABLITZ 58 AF-2 Nikon Bedienungsanleitung

7.6 Cordless remote mode (Remote)

• When „Remote OFF" appears, the cordless remote mode is deactivated.
• When „Remote Master" appears, the flash unit is operating as a guiding
master flash unit on the camera.
• When „Remote Slave" appears, the flash unit is operating completely as a sla-
ve flash unit. See also Section 21.
Setting procedure:
BEEP
Select
• Press the
Remote
appears on the display.
FB
• Select the „Remote" menu option by pressing the
Set
and
be highlighted.
• Confirm the selection of the special function by pres-
Remote
sing the
Master
• Select the desired setting with the
tons.
Set
The setting takes effect immediately.
• Press the button
CH1
M
reset to its normal view. If the button
A TTL
AZoom 28
1
B TTL+ /
F32 sed, the display is automatically reset to its normal
3
view after about 5 seconds.
Para Sel
Sel button repeatedly until „Select"
buttons. The selected menu option will
Set
button.
and
repeatedly until the screen is
is not pres-

7.7 Meter-Feet changeover (m/ft)

The maximum flash range indicated by the flash unit's display can either be
shown in meters or feet. The setting can be adjusted under the menu option
m/ft.
Setting procedure:
• Press the Sel button repeatedly until „Select"
appears on the display.
• Select the „m/ft" menu option by pressing the
and buttons. The selected menu option will be
highlighted.
• Confirm the selection of the special function by pres-
sing the Set button.
• Select the desired setting with the
tons. The setting takes effect immediately.
– When „m" is displayed, distances will be
but-
shown in meters.
– When „ft" is displayed, distances will be
shown in feet.
• Press the button repeatedly until the
display is reset to its normal state. If the
button is not pressed, the display is
automatically reset to its normal view
after about 5 seconds.
Zoom Ext
Select
m/ft
AF-BEAM
Set
m
and but-
Set
A F 4.5
m
AZoom 70
14 m ISO 200
131