Metz MECABLITZ 58 AF-2 Nikon Bedienungsanleitung Seite 123

Setting procedure:
A
Mode
• Press the
M
LC display.
Set • Choose the flash mode
arrows. The flash mode
setting takes effect immediately.
N24:f10
Hz
• Press the button
AZoom 24
1.2 m P1/32
the normal view. If the button
Mode Para Sel
display will change back to the normal view after
about 5 seconds.
Strobe number of flashes (N)
In strobe mode, the number of flashes per shot (N) can be selected.
The number of flashes can be set from 2 to 50 in intervals of one. The maximum
manual partial light output is automatically adjusted to this number.
Strobe flash frequency (f)
Strobe mode allows you to select the flash frequency (f), which indicates the
number of flashes per second. The number of flashes can be set from 2 to 50 in
intervals of one. The maximum manual partial light output is automatically adju-
sted to this number.
Mode button until „Mode" flashes on the
using the and
is then highlighted. The
to change the LC display back to
is not pressed, the
Setting procedure:
Para
• Press the button (Parameters) until the desired
flash parameter (N or f) flashes on the LC display.
• Set the desired value using the
tons. The setting takes effect immediately.
• Press the button to change the LC display back
to the normal view. If the button
the display will change back to the normal view after
about 5 seconds.
The maximum possible partial light output depends on the ISO and aperture set-
tings, and is automatically set in strobe mode. If you desire short flashes, you
can manually reduce the partial light output to the lowest value of 1/256.
The mecablitz LC display will indicate the flash-to-subject distance required for a
correct flash exposure, given the parameters selected. By changing the aperture
setting or the partial light output, this value can be adjusted to fit the actual
distance to the subject.
Setting procedure:
• Press the Para button (Parameters) until the desired
flash parameter
(F=f-stop or P=partial light output) appears on the
LC display.
• Set the desired value using the
tons. The setting takes effect immediately.
• Press the button to change the LC display back to
the normal view. If the button
display will change back to the normal view after
about 5 seconds.
Aperture and ISO settings do not appear on the
LC display in strobe mode. Strobe mode may not
be combined with an operational second reflec-
tor.
+
– 2.1 m
and but-
Para
is not pressed,
4,6 m
Para
+
–
and but-
is not pressed, the
2.1 m
Para
N24
+
–
F 4.0
MZoom 24
P1/1
– +
P1/32
+
–
123