Setting The Clock - Aiwa AV-D58 Bedienungsanleitung

SETTING THE CLOCK

When the AC cord is connected for the first time, the clock on
the display flashes.
Set the time as follows while the power is off.
1 Press ENTER.
The display becomes a little brighter.
2 Within 4 seconds, turn MULTI JOG to designate
the hour and the minute.
The time advances by turning it to the right, and decreases
by turning it to the left.
N/M on the main unit is also available. Press the button
repeatedly. To change the time rapidly in 10-minute steps, hold
it down.
3 Press ENTER.
The clock starts from 00 seconds.
NOTE
When the clock is set for the first time after purchase
Everything on the display will clear.
This is because the power economizing mode of the unit is
activated, and is not a malfunction.
The power economizing mode can be canceled. See page 8 for
details.
To correct the current time
Press POWER 6STANDBY/ON to turn the unit off. Carry out
steps 1 to 3 above.
To display the current time
Press CLOCK while pressing SHIFT on the remote control. The
clock is displayed for 4 seconds.
When operating on the main unit, press CLOCK while the power
is on and ENTER while the power is off (standby).
To switch to the 24-hour standard
Display the current time, and press BAND/DIGITAL/ANALOG on
the unit within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
In the 12-hour standard, "AM 12:00" indicates midnight and "PM
12:00" indicates noon.
If the clock display flashes while the power is off
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours, all
settings stored in memory after purchase need to be reset.
En
9
ENGLISH