Selecting Dts Surround - Aiwa AV-D58 Bedienungsanleitung

SELECTING DTS SURROUND

The optimal DTS surround modes and settings depend on the
type and placement of the speakers.
Check the current type and placement of your speakers and select
the recommended mode accordingly.
Recommended mode
Center speaker
Surround speaker
(Rear speaker)
No surround
speaker
4 ch mode: Select this mode when the center speaker is not
connected. All center channel signals are redistributed to the left
and right channel speakers.
3 STEREO mode: Select this mode when the surround speakers
are not connected.
TO SELECT DTS SURROUND MODE
Preparation
When selecting DTS surround mode, select the DIGITAL function
and play a disc recorded in DTS surround before selecting
the mode.
1 Press SURROUND and turn MULTI JOG to select
the appropriate mode.
The selected mode name appears on the display.
To select 2chSTEREO mode, press SURROUND repeatedly
until "2chSTEREO" appears.
22
ENGLISH
No center speaker
5.1ch 4 ch
3 STEREO 2chSTEREO
Before playing a disc, adjust the speaker level balance in Dolby
Digital or Dolby Pro Logic mode as described in page 19.
To adjust the balance while listening to the source, see the
right column in page 20 and follow the steps 2 and 3. The delay
time of the center and surround speakers cannot be adjusted in
DTS surround mode.
NOTE
• Depending on the sound source or listening condition, surround
effect may not be obtained even when DTS surround is selected.
• The full DTS surround effect cannot be obtained when using
software not recorded in DTS surround. In this case, use the
DSP surround system instead (see page 11).
• When headphones are plugged in, DTS surround mode is
automatically changed to "2chSTEREO."
• While headphones are plugged in, DTS surround mode cannot
be changed.
TO LISTEN TO THE ORIGINAL DTS
SOUND
When "dts" appears on the display, all the sound settings can be
canceled.
1 While DTS surround is activated, press ENTER
so that "BYPASSOFF" appears on the display.
2 Press ENTER again to display "BYPASS ON."
To restore the sound settings
Repeat steps 1 and 2 so that "BYPASSOFF" appears.