Starting The Programme - Electrolux WA SL2 E201 Benutzerhandbuch

Always obey the instructions that you find on the packaging of the detergent products.
Check the position of the flap
1. Pull out the detergent dispenser until it
stops.
2. Press the lever down to remove the
dispenser.
3. To use powder detergent, turn the flap
up.
4. To use liquid detergent, turn the flap
down.
5. Measure out the detergent and the fab-
ric conditioner.
6. Carefully close the detergent dispenser.
Make sure that the flap does not cause
a blockage when you close the drawer.
With the flap in the position DOWN:
– Do not use gelatinous or thick liquid
detergents.
– Do not put more liquid detergent
than the limit showed in the flap.
– Do not set the prewash phase.
– Do not set the delay start function.
SET THE DELAY START
1. Press button
5
the display shows the number of mi-
nutes or hours. The related symbols
comes on.
2. Press button
4
the countdown of the delay start.
When the countdown is completed, the
programme starts automatically.
Before you press button
appliance, you can cancel or change
the set of the delay start.
You cannot set the delay start with the
Steam programme.
CANCEL THE DELAY START
1. Press button
4
flashes.
2. Press button
5
the display shows 0'.
3. Press button
4
starts.

STARTING THE PROGRAMME

• Press button
4
The related indicator flashes no more.
• On the display all symbols related to the
load and to the quantity of detergent go
off.
If a delayed start is set, the appliance starts
the countdown.
The appliance adjust automatically the cy-
cle time to the laundry you have put in the
drum to have perfect washing results in
the minimum necessary time. After ap-
proximately 15 minutes from the start of
the programme, the display shows the
new time value.
INTERRUPT A PROGRAMME
1. Press button
4
electrolux 15
again and again until
, the appliance starts
4 to start the
. The related indicator
again and again until
. The programme
to start the programme.
. The indicator flashes.