Loading The Laundry - Electrolux WA SL2 E201 Benutzerhandbuch

14 electrolux

LOADING THE LAUNDRY

1. Open the appliance door.
2. The display (J) shows the maximum
load for the programme (MAX) and the
weight of the laundry (KG).
3. Put the laundry in the drum, one item at
time. Shake the items before you put
them in the drum.
4. On the display the weight of the laundry
updates by steps of kg 0.5. The weight
is indicative and changes with the type
of the laundry.
If you put in the drum more laundry
than the maximum load, the symbols
MAX and the value 0.0 start to flash.
You can wash your laundry but the wa-
ter and energy consumption increase.
To have the best consumption and
washing performance remove some
items until the symbols stop to flash.
The overload indication is available only
for programmes with a maximum load
lower than the appliance maximum
load.
USING THE DETERGENT AND ADDITIVES
The detergent compartment for the prewash phase and the soak programme.
Add the detergent for prewash and soak before the start of the programme.
The detergent compartment for the washing phase.
If you use a liquid detergent, put it immediately before you start the programme.
Liquid additives compartment (fabric conditioner, starch).
Put the product in the compartment before you start the programme.
This is the maximum level for the quantity of liquid additives.
The compartment for the stain remover.
Put the product in the compartment and set the stain function before you start
the programme.
Flap for powder or liquid detergent
Turn it (up or down) in the correct position to use powder or liquid detergent.
5. Close the door. The value 0.0 near the
symbol % on the display shows the
quantity of the detergent to use.
This data is indicative and refers to the
detergent quantity for a maximum load
that the manufacturer recommends.
Caution! Make sure that no laundry
stays between the seal and the door.
There is a risk of water leakage or
damage to the laundry.