Starting The Programme - Electrolux WASL6E 201 Benutzerinformation

18 electrolux
4. To use liquid detergent, turn the flap
down.
5. Measure out the detergent and the fab-
ric conditioner.
6. Carefully close the detergent dispenser.
Make sure that the flap does not cause
a blockage when you close the drawer.
With the flap in the position DOWN:
– Do not use gelatinous or thick liquid
detergents.
– Do not put more liquid detergent
than the limit showed in the flap.
– Do not set the prewash phase.
– Do not set the delay start function.
SET THE DELAY START
1. Touch button
set the desired delayed start. The dis-
play shows the expected end of the
programme
2. Touch button
the countdown of the delay start.
When the countdown is completed, the
programme starts automatically.
Before you touch button
appliance, you can cancel or change
the set of the delay start.
You cannot set the delay start with the
Steam programme.

STARTING THE PROGRAMME

1. Touch button
gramme. The indicator of button
stops to flash and is on with red colour.
If a delayed start is set, the appliance starts
the countdown.
The appliance adjust automatically the cy-
cle time to the laundry you have put in the
drum to have perfect washing results in
7
again and again to
6
, the appliance starts
6
to start the
6
to start the pro-
6
the minimum necessary time. After ap-
proximately 15 minutes from the start of
the programme, the display shows the
new time value.
INTERRUPT A PROGRAMME
1. Touch button
es.
2. Touch button
programme continues.
CANCEL A PROGRAMME
1. Press button
1
gramme and to deactivate the appli-
ance.
2. Press button
1
appliance. Now, you can set a new
washing programme.
The appliance does not drain the wa-
ter.
CHANGE A FUNCTION
You can change only some functions be-
fore they operate.
1. Touch button
es.
2. Change the function set.
3. Touch button
programme continues.
OPEN THE DOOR
While a programme or the delay start oper-
ates, the appliance door is locked.
To open the appliance door:
1. Touch button
bol in the display goes off and a mes-
sage tells you that the door is un-
locked.
2. Open the appliance door.
3. Close the appliance door and touch
6
button again. The programme or
the delay start continues.
If the temperature and the level of the
water is too high, the door lock symbol
stays on. You cannot open the door. If
necessary, do the following procedure
to open the door:
1. Deactivate the appliance.
2. Wait for some minutes.
3. Make sure that no water is in the
drum.
6
. The indicator flash-
6 again. The washing
to cancel the pro-
again to activate the
6
. The indicator flash-
6
again. The washing
6
. The door lock sym-